Garage door won't close: sensor repair in Wyckoff

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (551) 231-7762

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Wyckoff realigns or replaces the sensors and tests the safety reverse.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Wyckoff

Wyckoff's rebuilt and expanded houses often have three garage bays, which means three sets of sensors and three chances for one to be out of line. With mature trees from Sicomac to Franklin Avenue, leaves and acorns are the everyday cause each fall, and a quick sweep and a wipe of the lenses fixes most of it. When one bay keeps acting up after that, the sensor wire has usually been pinched or stapled through during the renovation and needs to be rerun.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Wyckoff

  • Wyckoff Avenue corridor: Colonials and split-levels toward Waldwick and Midland Park.
  • Cedar Hill: Northern streets toward Mahwah.

See the full Wyckoff service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 231-7762
Call (551) 231-7762